Texture-Based Modeling of Sheet Metal Forming and Springback

  • V. Schulze
  • A. Bertram
  • T. Böhlke
  • A. Krawietz

Abstract

In this paper the application of a crystal plasticity model for body-centered cubic crystals in the simulation of a sheet metal forming process is discussed. The material model parameters are identified by a combination of a texture approximation procedure and a conventional parameter identification scheme. In the application of a cup drawing process the model shows an improvement of the strain and earing prediction as well as the qualitative springback results in comparison with a conventional phenomenological model.

Published
2019-07-30
Section
Article

Most read articles by the same author(s)

1 2 3 4 > >>